Wright Storm Door Handle Installation: Step-by-Step Instructions
If you're a homeowner looking to enhance your home's security and curb appeal, installing a Wright storm door with a decorative handle can achieve both. This guide will walk you through the process of installing a Wright storm door handle, ensuring you achieve a perfect fit and functionality.
Before you start, gather your tools and materials. You'll need a Phillips screwdriver, a drill (if not using the screwdriver), a tape measure, a pencil, and, of course, your Wright storm door handle. Always ensure you're using the correct handle for your door model and size.
Preparation and Measurement
Begin by measuring your door to ensure the handle will fit correctly. The handle needs to be centered on the door, so measure the width of your door and mark the center point with a pencil.
![How to Install a Storm Door Handle Set [1080p]](https://i.pinimg.com/736x/b8/29/19/b8291939e5b49dc411fa8dd19f59f991.jpg)

![How to Install a Storm Door Handle with Deadbolt [1080p]](https://i.pinimg.com/736x/3c/f1/6b/3cf16bd34f30b2ff9f793f0d72f6bd2b.jpg)
Next, decide on the handle's position. Typically, handles are positioned between 36" and 42" from the ground for optimal usability. Measure and mark this point on your door.
Handling Sizes
Wright storm door handles come in various sizes to accommodate different door widths. Common sizes are 32", 36", and 40". Ensure you've chosen the correct size for your door before proceeding.



If your door's width doesn't match any of the standard sizes, you may need to adjust the handle's position slightly or consider a custom-made handle.
Identify and Prepare Handle Components
Unpackage your handle and ensure all components are intact. Wright handles usually include the handle itself, two mounting screws, and sometimes an escutcheon plate.
If you're installing the handle on an existing storm door, measure the existing mounting holes. If they don't match the new handle's hole pattern, you'll need to fill and sand the holes, then mark and drill new ones.






Installing the Wright Storm Door Handle
Now that you've prepared your door and handle, it's time for the installation.
Position the handle on your door, using the marks you've made as a guide. Ensure the handle is level and centered. If you're satisfied with the position, lightly mark the handle's mounting holes on the door.
Drilling Mounting Holes
Using a drill bit that's slightly smaller than the mounting screws, drill pilot holes at the marked points. This will prevent the door from splitting when you drive in the screws.

Safety Tip: Always wear safety goggles when drilling to protect your eyes from debris.
Mounting the Handle
With the pilot holes drilled, position the handle back on the door, ensuring it's still level and centered. Insert the mounting screws and use a Phillips screwdriver or drill to drive them in gently, stopping when the handle feels secure but not yet tightened.
Before fully tightening the screws, gently lift and lower the handle a few times to ensure it moves smoothly. If anything binds, adjust the screws slightly until the handle operates smoothly.
Securing the Handle
Once you're satisfied with the handle's movement, fully tighten the screws using a screwdriver or drill. Be careful not to overtighten, as this can strip the screws or cause the handle to bind.
If your handle came with an escutcheon plate, now's the time to attach it. Follow the manufacturer's instructions for the plate's installation.
Testing and Finalizing
Give your handle a few more tries, ensuring it opens and closes smoothly. If everything works as expected, you're done!
For additional security, consider using a deadbolt lock on your storm door. This can provide extra protection, especially if your main door doesn't have a deadbolt.
Installing a Wright storm door handle can significantly improve your home's security and aesthetic appeal. Always remember to measure twice and cut (or drill) once. With a little patience and careful measurement, you can achieve a professional-looking result. Happy installing!





