rheem rtex-18

Rheem RTEX-18 Tankless Water Heater: Specs, Pros, Cons & Buying Guide

By Rachel Garcia
AD

The Rheem RTEX-18 is an 18-kilowatt electric tankless water heater built to deliver hot water on demand without a storage tank. It belongs to Rheem's RTEX series, a lineup that ranges from compact point-of-use models up to 36 kW units designed for whole-home service in cold climates. Sitting in the middle of that range, the RTEX-18 has become one of the more popular choices for homeowners who want endless hot water but do not have natural gas available at the property.

Because it heats water only when a hot tap opens, the RTEX-18 eliminates the standby losses that come with a conventional tank. The trade-off is electrical demand. This is a serious appliance that needs dedicated circuits and a service panel with enough spare capacity to feed it, and understanding how it performs under real conditions is the difference between a smart purchase and an expensive mistake.

Rheem RTEX-18 Specs, Capacity, and Real-World Performance

The RTEX-18 produces 18 kilowatts of heating power at 240 volts, which works out to a maximum draw of roughly 75 amps. That output is split across two independent heating chambers, each supplied by its own circuit. The unit is small and wall mounted, measuring approximately 17 inches tall, 14 inches wide, and under 4 inches deep, and it weighs only about 13 pounds. With no tank and no venting requirements, it can go in a utility closet, a garage wall, or a mechanical room where a tank simply would not fit.

AD
Rheem Rtex-18 18kw 240v Tankless Electric Water Heater
Rheem Rtex-18 18kw 240v Tankless Electric Water Heater
Rheem 3 in. x 5 in. Vertical Concentric Termination Vent Kit Stainless Steel for Mid Efficiency Tankless Gas Water Heaters RTG20211 - The Home Depot
Rheem 3 in. x 5 in. Vertical Concentric Termination Vent Kit Stainless Steel for Mid Efficiency Tankless Gas Water Heaters RTG20211 - The Home Depot
Rheem RTEX-18 Electric Tankless Water Heater Review
Rheem RTEX-18 Electric Tankless Water Heater Review

Rheem designed this model around a modulating heating system. Rather than firing every element at full power the moment water starts moving, the unit stages its elements based on flow rate and the temperature you select. A single bathroom faucet might only activate a fraction of the available capacity, while a shower running alongside a dishwasher or laundry cycle can push the heater close to its rated limit. Digital controls let you set outlet temperature between roughly 80°F and 140°F, and the display reports the set point along with diagnostic codes when service is needed.

Power Requirements and Electrical Capacity

The electrical side is the first thing to verify before ordering an RTEX-18. The unit calls for two 40-amp double-pole breakers and, in most installations, two runs of 8 AWG copper wire. Long circuit runs, hot attic or garage locations, or stricter local amendments can require 6 AWG instead, which raises the material cost. A 240-volt supply is mandatory, and the heater should sit on dedicated circuits with a disconnect within sight of the unit.

Rheem RTEX-18KW Tankless Water Heater| The Best Picker
Rheem RTEX-18KW Tankless Water Heater| The Best Picker
Rheem RTEX-24 Professional Classic Electric Tankless Water Heater
Rheem RTEX-24 Professional Classic Electric Tankless Water Heater
RHEEM GHE 80-200 SERIES TRITON™
RHEEM GHE 80-200 SERIES TRITON™

In practical terms, this heater belongs in a home with a 200-amp service and enough spare capacity to absorb 75 amps of intermittent load. If your home has a 100-amp panel, or a 150-amp panel already carrying an electric range, an electric dryer, and central air conditioning, a load calculation will almost certainly be required. This is not optional guesswork either. Most jurisdictions expect a load calculation as part of the permit application, and it determines whether a service upgrade has to happen before the heater can be connected at all.

Flow Rate and Temperature Rise in Practice

Flow rate is where electric tankless heaters succeed or fail, and the figure that actually matters is temperature rise rather than the gallons-per-minute number on the packaging. Temperature rise is the gap between incoming groundwater temperature and the hot water temperature you want at the fixture. An 18 kW heater raises water by a fixed number of degrees for every gallon per minute moving through it, so as flow increases, the achievable temperature rise falls.

AD

Groundwater in southern states can sit between 70°F and 80°F much of the year, while parts of the upper Midwest and Northeast see inlet temperatures near 40°F in the dead of winter. That spread changes what the RTEX-18 can realistically handle, as the approximate figures below illustrate.

Rheem RTG-70XLN-3 7 GPM Outdoor Tankless Water Heater Natural Gas High-Efficiency Non-Condensing New
Rheem RTG-70XLN-3 7 GPM Outdoor Tankless Water Heater Natural Gas High-Efficiency Non-Condensing New
RTGH Series 157 MBH Indoor Condensing Natural Gas Tankless Water Heater
RTGH Series 157 MBH Indoor Condensing Natural Gas Tankless Water Heater
43-25135-11 - OEM Rheem Capacitor 40/7.5 uf 440
43-25135-11 - OEM Rheem Capacitor 40/7.5 uf 440
Rheem Electric Water Heater
Rheem Electric Water Heater
Rheem / Richmond Rmtex-18 Essential Tankless Electric Water Heater, 3-1/2" 3.17
Rheem / Richmond Rmtex-18 Essential Tankless Electric Water Heater, 3-1/2" 3.17
Top Small Tankless Water Heaters for Efficient Home Heating in 2025
Top Small Tankless Water Heaters for Efficient Home Heating in 2025
Temperature RiseApproximate Flow RateTypical Scenario
30°FAbout 4.1 GPMWarm inlet water (70°F to 80°F), whole-home demand
40°FAbout 3.1 GPMShower plus a low-flow faucet in a mild climate
50°FAbout 2.5 GPMOne shower in a cool climate
70°FAbout 1.8 GPMNorthern winter, one fixture at a time

Those numbers are approximations, not guarantees, because actual output depends on supply voltage, inlet temperature, and the fixture flow restrictors in your home. The key takeaway is that the RTEX-18 can serve a whole house in a warm climate, but in a cold climate it behaves more like a single-shower unit during the winter months. If your household routinely runs two showers at once in January, this is the wrong heater for the job.

Installing the Rheem RTEX-18: Costs, Wiring, and Upkeep

Installing an electric tankless heater splits neatly into two jobs, and only one of them is friendly to a confident do-it-yourselfer. Hanging the unit, connecting the cold inlet and hot outlet, and mounting it plumb on a wall are straightforward tasks. Running two dedicated 240-volt circuits, installing breakers, and tying into a panel is not, and it is work that generally requires a licensed electrician and a permit.

AD

Budget for the project as a whole rather than just the hardware. The heater itself typically sells somewhere between $400 and $550, but professional installation commonly adds $500 to $1,500 depending on circuit length, panel layout, and local labor rates. If the service panel needs an upgrade, that number can climb to $2,000 or more, and a panel upgrade is far more common than most buyers expect.

an automatic water heater is shown with measurements
an automatic water heater is shown with measurements
Rheem Ikonic Super High Efficiency Tankless Gas Water Heater, 8.4 GPM
Rheem Ikonic Super High Efficiency Tankless Gas Water Heater, 8.4 GPM

Electrical Panel and Wiring Considerations

Two 40-amp double-pole breakers are the baseline requirement, but the panel also needs physical space for them. A full panel with no open slots means either a subpanel or a service upgrade, neither of which is cheap. Wire sizing matters just as much. Short runs with 8 AWG copper keep costs down, while runs over roughly 50 to 60 feet usually need to step up to 6 AWG to control voltage drop at 75 amps.

There are also practical installation questions worth answering early. Where does the disconnect go? Is there a clear path from the panel to the mounting location? Does the local inspector require a dedicated circuit label or a specific breaker type? On a recent garage or basement install, the wiring is often the simplest part. In a finished home where the panel sits at the opposite end of the house from the bathroom wall, the labor can easily exceed the price of the heater itself.

AD

Purchase Price, Installation Costs, and Maintenance

Total installed cost for an RTEX-18 most commonly lands between $1,000 and $2,000 when no panel work is needed, and higher when it is. Beyond the heater and the electrician, add permit fees and any plumbing modifications needed to reroute supply lines. If you are replacing a tank, removing and disposing of the old unit usually carries a small additional charge, though many homeowners handle that themselves.

Maintenance on an electric tankless heater is minimal, but it is not zero. In hard water areas, scale builds up on the heating elements and reduces performance over time, so a periodic descale flush with a mild descaler is worth the effort every year or two. Inlet filter screens should be checked and cleaned as well, particularly on well water systems. Rheem provides a limited warranty on the RTEX-18, but coverage terms vary by application and change over time, so confirm the current documentation for residential installations before you buy.

Weighing the Rheem RTEX-18 Against Your Needs

Judged on its own terms, the RTEX-18 does exactly what an 18 kW electric tankless heater should do. It provides hot water within seconds of opening a tap, holds temperature steadily as long as demand stays within its capacity, takes up almost no wall space, and requires no venting, no gas line, and no combustion air. It is also quiet, with only the faint hum of flowing water and the click of staged elements.

Against a gas tankless unit, it gives up ground on recovery speed and simultaneous fixture capacity. Against a traditional tank, it wins on space and standby efficiency but loses on upfront cost and electrical complexity. The right answer depends entirely on your climate, your panel, and how many people in your house want hot water at the same moment.

Where This 18 kW Unit Performs Best

The RTEX-18 shines in warm and moderate climates where inlet water temperatures stay above roughly 60°F. In Florida, southern Texas, Arizona, and coastal California, it can genuinely serve a small to mid-size home with two bathrooms, provided fixtures are not all running at once. It is also an excellent fit for point-of-use applications such as a detached garage, a workshop sink, a pool house, an accessory dwelling unit, or a guest bathroom far from the main water heater.

Homes without access to natural gas or propane are another natural match, since the unit needs nothing but electricity. Because there is no standing tank, there is no energy lost reheating water nobody is using, and electric resistance heating converts nearly all of its input into heat at the point of use. For a property with adequate electrical service and a modest hot water load, that combination is hard to beat on simplicity.

Drawbacks and When to Choose a Different Model

The limitations are real and worth stating plainly. The RTEX-18 cannot serve a cold-climate whole house during winter, it will struggle if two showers run simultaneously in a cool region, and it stops producing hot water entirely during a power outage. It also has a minimum activation flow, usually around half a gallon per minute, which means a trickle of water at a bathroom sink may not trigger the elements at all. Hard water accelerates scaling, and ignoring that shortens the unit's life.

If your demand exceeds what 18 kW can deliver, step up within the same family. The Rheem RTEX-24 and RTEX-27 offer more capacity for colder climates and larger households, though they demand more panel space and heavier wiring. Where natural gas is available, a gas tankless model often makes more sense for whole-home use in northern states. And if efficiency is the priority rather than endless hot water, a heat pump water heater will use far less electricity over its lifetime. Matching the technology to the house beats forcing a single product into a role it was never meant to fill.

Before you commit to an RTEX-18, spend a few minutes on two measurements: the size of your electrical service and the temperature of your incoming water in the coldest month. Those two numbers tell you more about whether this heater will satisfy your household than any marketing sheet ever could. If both check out, the RTEX-18 delivers compact, tank-free hot water with very little fuss for years to come. If they do not, the same research will point you toward the model that actually fits, and you will be glad you looked before the first cold shower.

AD