installing package bees on drawn comb

Installing Package Bees on Drawn Comb: A Step-by-Step Guide for Beekeepers

By Laura Lopez
AD

Installing package bees on drawn comb is one of the fastest ways to turn a new colony into a productive hive. Instead of asking bees to build wax from scratch, you give them a ready-made nursery and pantry. The queen can lay sooner, foragers can store nectar sooner, and the colony spends less energy on construction. But drawn comb also demands careful preparation. It can carry pests, disease, or chemical residue. The method rewards beekeepers who inspect first and install with calm, deliberate movements.

Package bees usually arrive in a screened box with a mated queen in a separate cage and a can of syrup. When those bees land in a hive filled with drawn comb, they do not have to start from zero. That advantage can mean the difference between a colony that builds up before the first nectar flow and one that lags behind. However, the same comb that saves time can create problems if it is old, contaminated, or stored poorly. The goal is to pair the package's energy with clean, intact, well-placed frames.

Why Drawn Comb Changes the Package Installation Equation

Drawn comb is wax that bees have already built into cells. Those cells may be empty, or they may hold honey and pollen. For a package, drawn comb is like moving into a furnished home. The bees can focus on raising brood, regulating temperature, and foraging instead of secreting wax. Wax production is expensive. It takes roughly six to eight pounds of honey to produce one pound of wax, so every frame already drawn is a saved calorie.

AD
How To Install Package Bees in a Langstroth Hive
How To Install Package Bees in a Langstroth Hive
Building comb next to foundation
Building comb next to foundation
a beekeeper holding up a frame full of bees
a beekeeper holding up a frame full of bees

Yet drawn comb is not neutral real estate. It has a history. It may come from a hive that collapsed, swarmed, or was treated with chemicals. It may harbor wax moth eggs, small hive beetle larvae, chalkbrood spores, or pesticide residue. Before you install a package on it, you need to know where it came from and how it was stored. Clean, straight, pest-free comb is an asset. Dark, greasy, odoriferous comb is a liability.

Benefits of Using Drawn Comb for Package Bees

The biggest benefit is speed. A package installed on drawn comb can have the queen out of her cage and laying within a few days. On foundation or foundationless frames, the colony often spends its first week or two building comb before the queen has enough cells to lay a solid pattern. That delay can push brood rearing into a dearth or poor weather.

10 Tips To Draw Comb FAST! Beekeeping 101 #beekeeping
10 Tips To Draw Comb FAST! Beekeeping 101 #beekeeping
a bunch of bees that are in a box
a bunch of bees that are in a box
How to Encourage Bees to Build Comb Faster- Carolina Honeybees
How to Encourage Bees to Build Comb Faster- Carolina Honeybees

Drawn comb also gives the bees a place to store the syrup you feed them. When you feed a new package, you want the syrup to go into cells, not drip onto the bottom board or ferment in a feeder. Drawn frames absorb that syrup and stimulate wax production only where it is needed. In cool spring weather, the insulating value of drawn comb can help the cluster stay warm.

Risks and Limitations of Drawn Comb

The main risk is contamination. Comb acts like a sponge for pesticides, especially those used in agriculture or for varroa control. If the comb came from a hive treated with chemicals that are not approved for honey supers or brood chambers, residues can persist. Those residues may harm brood or contaminate honey. Disease is another concern. American foulbrood spores can survive for decades in old comb, and no package can outrun that infection.

AD

Physical damage matters too. Drawn comb can sag, crack, or fall out of the frame in hot weather. If the bees have chewed holes through it or if wax moths have tunneled through it, the frame may be too weak to support a cluster. Small hive beetles also love old comb with pollen. A package may be strong enough to handle minor damage, but severe damage gives pests a foothold before the colony has guard bees on duty.

Installing New Honeybees and Checking the Queens - The Martha Stewart Blog
Installing New Honeybees and Checking the Queens - The Martha Stewart Blog
a person holding onto a piece of wood that is attached to the side of a wall
a person holding onto a piece of wood that is attached to the side of a wall
Bees creating new comb on the frame adjacent to plastic foundation
Bees creating new comb on the frame adjacent to plastic foundation
Installing Bees From a Package
Installing Bees From a Package
a man kneeling down next to a beehive filled with bees
a man kneeling down next to a beehive filled with bees
How to Install Package Bees – The Beginners Guide
How to Install Package Bees – The Beginners Guide

Preparing Hives and Drawn Comb Before Package Arrival

Preparation starts days or weeks before the package arrives. You want the hive stand level, the bottom board secure, and the entrance reducer ready. The brood chamber should be clean and free of debris. If you are using drawn comb, inspect every frame under good light. Look for signs of wax moth webbing, beetle slime, mold, or mouse damage. Remove any frame that is more than lightly damaged.

Think about how many drawn frames to give the package. A three-pound package can handle a ten-frame brood box if most frames are drawn and there is space for the cluster. But if the comb is very old or the weather is cold, starting with fewer frames or using a divider board can help the bees regulate temperature. The point is not to give them a cavern. The point is to give them a manageable home with room to expand.

AD

Inspecting and Cleaning Drawn Comb

Start by pulling each frame and checking the midrib. The wax should be light to medium brown, dry, and intact. White or black fuzzy patches, webbing, or a sour smell indicate trouble. If you see chalkbrood mummies, scrape them out and freeze the frame for at least forty-eight hours. Freezing kills wax moth eggs and larvae but does not eliminate American foulbrood spores. If foulbrood is suspected, do not use the comb and contact your local apiary inspector.

a man holding up a beehive full of bees
a man holding up a beehive full of bees
a man holding up a beehive with lots of bees in it's frame
a man holding up a beehive with lots of bees in it's frame
Adding comb guides to regular bee hive frames to go foundationless
Adding comb guides to regular bee hive frames to go foundationless
Bees on their comb 🐝
Bees on their comb 🐝

For minor mold, you can brush it off and let the frame air dry in a warm, well-ventilated place. Do not use bleach or harsh cleaners on wax. If the comb smells like chemicals or has visible pesticide crystals, discard it. A package is too valuable to risk on questionable comb. When in doubt, use fresh foundation or sacrifice the old frame to the solar wax melter.

Setting Up the Brood Chamber and Entrance

Arrange the drawn frames in the brood chamber so the cluster has a tight, continuous space. Place frames with some empty cells near the center and honey or pollen frames toward the outside. If you have a frame of capped honey from a trusted source, put it next to the brood area. This gives the bees immediate stores and reduces the chance they will abscond in bad weather. Keep frames pushed together, but do not jam them so hard that you crush bees.

AD

Use an entrance reducer on the smallest setting that allows traffic. A new package is vulnerable to robbing, especially if there is no nectar flow. A reduced entrance also helps the bees defend against mice and beetles. If you use a screened bottom board, close it for the first week to retain heat. Face the entrance away from prevailing winds if possible, and make sure the hive gets morning sun.

Step-by-Step Installation of Package Bees on Drawn Comb

Installing a package on drawn comb is similar to installing on foundation, but you need to be gentler with the frames. The bees are already stressed from shipping. The comb is already built, so there is no need to rush them into building. Work in the late afternoon or early evening when foragers are less active. Have your smoker lit but use it sparingly. A little smoke at the entrance can calm the bees, but too much smoke drives them up into the package and makes shaking harder.

Set the package on the ground near the hive and remove the feeder can only when you are ready. The bees will stay in the package for a short time, but they can overheat in direct sun. Have a spray bottle of 1:1 syrup ready, but do not soak the bees. A light mist can keep them from flying, but wet bees can chill. The goal is a quick, controlled transfer that leaves the queen safe and the colony united.

Handling the Package and Queen

Pry off the cover and remove the syrup can. The queen cage is usually stapled or suspended near the top. Gently pull it out and set it aside in the shade. Check the queen cage for attendants and make sure the queen is alive. If the cage has a cork and a candy plug, remove the cork from the candy end, not the end with the queen. If the candy is hard, poke a small hole through it with a nail or toothpick. Do not release the queen directly into the hive unless the colony has been queenless for a while and you know the bees will accept her.

Place the queen cage between two drawn frames near the center of the brood nest. The screen side should face down or sideways so bees can feed and attend her. Make sure the cage is not buried in wax or propolis. If the comb is thick, wedge the cage between frames without crushing bees. Some beekeepers use a rubber band or a small nail to secure the cage. The queen needs airflow and access to workers. She does not need a wide-open space.

Shaking Bees Into the Hive

Once the queen cage is placed, turn the package upside down over the brood chamber. Give it a firm downward shake. Most of the bees will fall onto the frames and into the spaces between them. Do not shake the package from a height that injures bees. A sharp, controlled motion works better than a long, violent one. If bees cling to the package, give it another shake or set it at the entrance with the opening facing the hive. The remaining bees will usually walk in.

After the main shake, gently replace the frames you removed. Push them together to maintain bee space. Do not worry if some bees are on top of the frames or on the inner cover. They will move down. If you have a drawn comb frame that is especially fragile, avoid dropping bees directly onto it. Shake the package over a less delicate frame or over the top bars, then let the bees spread out naturally.

Post-Installation Care and Feeding

Feed the colony immediately with 1:1 sugar syrup. A package has no stored honey, and drawn comb does not change that. Use an entrance feeder, top feeder, or frame feeder, but choose one that does not drown bees. If you use an entrance feeder, reduce the entrance so robbers cannot get in. Check the feeder every few days and refill before it runs dry. In cool weather, a top feeder is often safer because it keeps the syrup warm and accessible.

Leave the hive alone for at least three to five days. Then do a quick check to see if the queen has been released. Look for eggs or young larvae one week after installation. If the queen is still in the cage after five days, release her manually by removing the candy plug or screen. If the bees have built burr comb around the cage, gently remove it. Once the queen is laying, you can remove the empty package and any leftover dead bees from the entrance.

Managing the Colony After the Package Settles

A package on drawn comb can build up quickly, but it still needs support. The queen may fill the first brood chamber faster than you expect. Watch for congestion and add a second box when the bees are using most of the frames. If you gave them old drawn comb, monitor for disease and pests. Small hive beetles can lay eggs in pollen-packed cells, and wax moths can appear if the colony is weak. A strong, well-fed colony is the best defense.

Continue feeding until the bees stop taking syrup and there is a nectar flow. Do not assume drawn comb means the colony is established. The queen must lay, the workers must raise brood, and the foragers must bring in pollen and nectar. A new package can still abscond if conditions are poor. Keep the entrance reduced until the colony is strong enough to defend itself. Then expand slowly, one frame at a time.

Monitoring Brood Pattern and Queen Acceptance

The first brood pattern tells you a lot. A good queen lays in a solid, circular pattern with few skipped cells. If the pattern is spotty, it may indicate a failing queen, poor nutrition, or disease. Check for eggs, larvae, and capped brood. Eggs are small and stand upright in the cell. Larvae should be white and glistening. Capped brood should be tan and slightly domed. If you see sunken, perforated cappings, investigate immediately.

Queen acceptance is usually obvious by the bees' behavior. If workers are calm and ignoring the queen cage, they likely accept her. If they are balling the cage or biting at the screen, they may be rejecting her. In that case, leave the cage in place longer or requeen with a different queen. Do not release a queen into a colony that is actively attacking her. Patience often solves the problem.

Expanding the Hive and Adding Supers

Once the bees have filled eight of ten frames with brood, food, and bees, add another brood box or a honey super. If you are using drawn comb in the super, the bees will accept it quickly. If you are using foundation, expect them to draw it more slowly. Place new frames between existing drawn frames to encourage straight comb. Do not add too much space at once, especially in cool weather. Empty space can chill brood and invite pests.

When the colony is strong, you can move drawn frames from the brood chamber to the super to guide bees upward. Replace them with new frames or foundation. This rotation keeps the brood nest from becoming congested and gives the queen room to lay. It also helps you manage old comb. Replace two to three old frames per year with fresh foundation to reduce disease and pesticide buildup.

The installation itself is only the opening move. The real work happens in the quiet days that follow, when the queen begins to lay and the first foragers return with pollen. Walk away from the hive knowing you gave the package a fair start: clean frames, a secure entrance, steady syrup, and a queen with room to work. Your next inspection will tell the rest of the story, and the bees will write it one cell at a time.

AD