IKEA PAX Hinged Door Installation Guide: Easy Steps
Tackling the installation of frameless hinged doors on your PAX wardrobe from IKEA can seem like a daunting task, but with the right guidance and a few simple steps, you'll be enjoying the seamless look of your new doors in no time. Let's dive into this comprehensive guide, assisted by professionals and designed to ensure your project runs smoothly.
Before you start, gather your IKEA PAX hinged doors, the provided tools - an Allen key or screwdriver, a tape measure, and a pencil - and set up your workspace. Make sure your wardrobe is securely anchored to the wall for safety.
The Preparatory Steps
Begin by ensuring your PAX wardrobe is level and square. This will help you align the doors correctly and maintain their functionality throughout their lifespan.



Next, mark the hinge positions on the wardrobe. With the door closed, measure down from the top of the doorframe and up from the bottom, then mark these points on both sides of the wardrobe. These marks will guide you in installing the hinges.
Installing the Hinges
Each PAX door comes with three hinges. To install, align the hinge with the mark on the wardrobe, and using an Allen key or screwdriver, secure it in place. Ensure the hinge is level and that the screw is fully seated in the pre-drilled hole.



Repeat this process for all hinges on the wardrobe. If you're installing a bifold door, ensure the hinges on both doors are aligned and mirror each other for a seamless opening mechanism.
Aligning the Stops
Stops are crucial to prevent the door from swinging too far and ensure a smooth close. IKEA provides them with your PAX hinged doors. Position the stops on the wardrobe's inner frame, aligning them with the hinge positions. Ensure they're level and adjusted so the door closes with a gentle click.
Using a pencil, mark the stop's position. Unscrew the stop, drill a pilot hole, then reattach the stop using the provided screws. Repeat for all stops, both top and bottom.






Attaching the Door
Once the hinges are securely in place and the stops are aligned, it's time to attach the door. Start by placing the top hinge into the corresponding wardrobe hinge. If you're installing a bifold door, connect the two doors with the long pin of the middle hinge first.
Slowly swing the door into the open position, guiding it onto the hinges. Secure the middle hinge, ensuring the door stays level and aligned. Open and close the door several times to ensure it operates smoothly and closes with a gentle click.
Finishing Touches
With the door now in place, you can attach any additional hardware, like handles or knobs. Measure and mark the center of the door (vertically if you're using a handle, horizontally if you're using a knob). Align the hardware with the mark and use the provided screws to secure it in place.

Finally, check your door's functionality and make any necessary adjustments. If needed, adjust the stop's position or tighten/loosen the hinge screws. Once you're satisfied, step back and enjoy your newly installed IKEA PAX hinged doors!
Remember, patience and precision are key during this process. Don't rush and always double-check your measurements and alignments. Happy DIY!





