Step-by-Step: Removing a Delta Roman Tub Faucet
uintRemoving a Delta Roman tub faucet can seem like a daunting task, but with the right steps and tools, it can be a breeze. Whether you're trying to repair it, replace it, or simply clean it, knowing how to remove a Delta Roman tub faucet can save you time and money. Let's dive into a step-by-step guide to help you conquer this task.
Before you start, gather your tools. You'll need an adjustable wrench, a pair of pliers, a flathead screwdriver, and possibly a basin wrench, depending on the setup of your tub faucet. It's also a good idea to have a towel or bowl on hand to catch any water drips.
Preparation and Gathering Tools
Ensuring you have the right tools is crucial before starting any project. For this job, you'll need an adjustable wrench, a pair of pliers, a flathead screwdriver, and optionally, a basin wrench.



You'll also want to have a towel or bowl nearby to catching any water drips. It's a good idea to turn off the water supply to your tub before you start. Most tubs have isolation valves under the sink that you can turn clockwise to shut off the water.
Turning Off the Water Supply
Before you begin any work on your tub faucet, it's important to turn off the water supply to prevent leaks and water damage.



Most tubs have isolation valves under the sink. To shut off the water, turn the valve clockwise until it stops. You can use a flathead screwdriver to help with this if needed.
Locating and Removing the Escutcheons
The escutcheons are the decorative plates that cover the hole in the tub deck where the faucet sits. Removing these will give you access to the nuts and bolts that hold the faucet in place.
Use an adjustable wrench to unscrew the nut on the underside of the tub deck. You might need a basin wrench for this, as the space can be tight. Once the nut is loose, use pliers to pull it all the way off. Repeat this process for each escutcheon.






Removing the Faucet Base
With the escutcheons removed, you can now access the nuts and bolts that secure the faucet to the tub.
Use your adjustable wrench or basin wrench to loosen and remove the nuts that hold the faucet base in place. Be careful not to scratch the tub finish with your tools.
Unthreading the Pipes
The pipes that connect your faucet to the water supply will have to come out too. The process can vary depending on the type of pipe and connector used.
If you have a flexible supply tube, you can usually just unthread it from the faucet and the supply pipe by hand. If the pipes are threaded, you might need to use a pipe wrench to loosen them.
Cleaning the Tubdeck
With the faucet and all its components removed, it's a good time to clean the tub deck where the faucet was attached.
Use a mild cleaning solution and a soft cloth to clean the area. If there are any stains or residue from the old faucet, you can use a bit of elbow grease to get them off. Be sure to rinse the area with clean water when you're done.
Reinstalling a New Faucet or Repairing the Old One
Now that your Delta Roman tub faucet is removed, you can either repair the old one if the problem was minor, or install a new one if it was beyond repair.
To reinstall a new faucet, follow the manufacturer's instructions. They will guide you through the process step by step. Ensure you apply a layer of plumber's putty under the new faucet to create a watertight seal.
Maintaining your tub faucet doesn't have to be hard. Regular cleaning and prompt repairs can help extend the life of your fixture significantly.





