Easy Bathroom Vinyl Flooring Install: No Toilet Removal
Installing vinyl flooring in your bathroom can enhance its aesthetic appeal and longevity. While removing the toilet might seem the conventional way, it's actually possible to install the flooring without moving it, saving you time and effort. With the right tools and techniques, you too can achieve a professional-looking finish in your bathroom. Let's dive into a step-by-step guide on how to do just that.
Before we start, ensure you have the necessary tools. You'll require a utility knife, a straight edge, a level, a measuring tape, a chalk line, a pry bar, flooring adhesive, a trowel, spacers, vinyl flooring, and underlayment if not already installed. Always safety first – wear gloves and protective eyewear during installation.
The Perfect Preparation
Preparation is key to a successful vinyl flooring installation. Begin by ensuring your bathroom's subfloor is clean, dry, and structurally sound. Remove any old flooring, but leave the toilet intact.



Measuring and Planning
Accurate measurements are crucial to avoid companions cuts and ensure a smooth installation. Measure the length and width of your bathroom, then use these dimensions to determine how much vinyl flooring you'll need. Add a few extra square feet for cutting accuracy and potential waste.
Plan your layout, considering the direction of light in the room. Lighter colors reflect light, making a small bathroom seem bigger, while darker hues create a cozy atmosphere. Lay out your design on paper first to help visualize the final look.



Preparing the Toilet Area
Vinyl flooring shouldn't go under the toilet as water can accumulate and cause damage. Instead, install a toilet flange that sits on top of the flooring. First, remove the existing wax ring and scrap the area clean. Then, insert the new toilet flange, sealing it with silicone caulk.
Once the caulk is dry, reattach the toilet to the flange, ensuring it's securely mounted. Now your vinyl flooring can be installed up to the toilet, leaving a space for your feet when you sit down.
Installing the Vinyl Flooring
Now that everything is prepared, it's time to lay down your new vinyl flooring. Start from one corner of the room, generally the least noticeable one, and work your way across the room.






Laying the Base Layer
If your bathroom doesn't already have underlayment, install it now. Underlayment provides an extra layer of protection against moisture and helps with soundproofing. Tack it down using a staple gun and cut it to fit around any vinyl flooring.
Spread flooring adhesive onto your subfloor using a trowel. Work in small sections at a time, laying the vinyl flooring on top. Use spacers to maintain consistent gaps between planks. Allow the adhesive to dry according to the manufacturer's instructions before walking on it.
Installing the Vinyl Planks
Starting from your designated corner, lay the first vinyl plank down and secure it into place. Use a tapping block and hammer to ensure a snug fit, but be careful not to damage the vinyl.

Continue laying the planks, using spacers to maintain consistent gaps and a tapping block to secure each one. Measure and cut planks as needed using a utility knife and straight edge. Use a chalk line to score the vinyl, then snap it along the line. Finally, use the utility knife to trim any rough edges.
Finishing Touches
Once all your planks are laid, remove the spacers. At this stage, you should have a gap of about 1/8-inch around all walls. Use a pull bar to install quarter round or threshold strips where needed.
Finally, trim the toilet caulk line to create a tidy, professional finish. Your vinyl flooring installation is now complete. Congratulations!
Regularly clean your vinyl flooring according to the manufacturer's instructions to keep it looking its best. With your new vinyl flooring, your bathroom's not only more comfortable but also easier to maintain – a win-win! Enjoy your updated space and the peace of mind that comes with knowing you did it all yourself.





