How to Frame an AngledDoorway
Framing an angled doorway can enhance your home's appeal and functionality. This task may seem daunting, but with the right approach and tools, it's accessible to any homeowner. Let's dive into the steps for framing an angled doorway, ensuring you obtain a professional finish.
First, you need to understand that angled doorways are typically found in sloped or vaulted ceilings. The angle can vary from a soft 30 degrees to a sharper 45 degrees. Regardless of the angle, the process remains similar. Let's proceed with the general steps, highlighting the differences where necessary.
Assessing & Measuring the Angled Doorway
Before you begin, measure the width and height of the doorway. For angled doorways, measure the height at the top and bottom to account for any differences due to the slope.



The angle presents an extra challenge. Mark the angle on a piece of paper or use a protractor if it's not obvious. This measurement will help you account for the angle when cutting lumber.
Choosing the Right Materials
For the frame, you typically need 1x4 or 1x6 lumber, depending on the size of your doorway. Ensure it's straight and free of knots. Stud—or construction—grade lumber is usually best for such tasks.



For angled doorways, consider using materials with greater flexibility, such as flexible corner bead for the drywall. This will help accommodate the angle and reduce the risk of cracks.
Creating the Door Jamb
The jamb is the vertical frame that surrounds the doorway. Cut two top and two bottom pieces of lumber according to your measurements. Account for the angle when cutting the top pieces.
Assemble these pieces, nailing them together to form a rectangle. Ensure the frame is square by measuring diagonally from corner to corner. Adjust as necessary until both diagonals are equal.






Installing the Door Frame
With your frame assembled, it's time to install it. Installing angled doorways can be more complex due to the angle, but with the right technique, it's achievable.
Start by marking the position of the frame on the rough opening. Use a level to ensure the bottom of the frame is level. For angled doorways, ensure the top of the frame is straight and flush with the angle of the ceiling.
Aligning and Securing the Frame
Position the frame and use shims to ensure it's plumb (vertical) and level. Nail it into place using 16d framing nails. Remember to nail through the face of the jamb and into the studs, not just the edge.
For angled doorways, you might need to secure the top of the frame with additional nails or screws into the angle of the ceiling. Ensure you're not nailing directly into the drywall, as this can compromise its structural integrity.
Finishing the Door Frame
Once the frame is secure, you can start finishing the project. Install the drywall, trimming it to fit around the frame. Use flexible corner bead to accommodate the angle.
After the drywall compound dries, sand, prime, and paint the frame. If needed, install the door using the hinges, ensuring they align with the strike plate on the jamb.
Framing an angled doorway might involve a little more planning and skill than a standard doorway, but with careful measurements and precise cuts, you can create a beautiful addition to your home. Happy building!





