How to Fix a Loose Pot Handle
Accidentally burned off the handle of your favorite pot? Don't despair! Reattaching a pot handle is not only possible, but also a rewarding DIY project. This step-by-step guide will walk you through how to fix a pot handle, using materials readily available at your hardware store.
Before we dive into the process, let's discuss the two common types of pot handles. The first is the riveted handle, which is attached using rivets. The second is the threaded handle, which screws onto the pot. Both types can be repaired, so let's explore how.
Repairing a Riveted Pot Handle
Riveted handles are more common on cast iron and aluminum pots. They provide a sturdy grip but can come loose over time or with excessive heat. Here's how to reattach a riveted handle:



First, gather your materials. You'll need a new handle, replacement rivets, a drill, a rivet setter, and a hammer. If the rivets are already loose, remove them using the rivet setter. If they're too stubborn, heat the rivet with a torch to expand the metal, then try again.
Preparing the Handle and Pot
Once the rivets are removed, clean the area with a wire brush to remove any rust or debris. Drill new holes in the handle and the pot where the rivets will go. Make sure the holes are the same size as your replacement rivets.



To ensure the handle is perfectly aligned, place it on the pot and mark the center of the new holes. Then, use these marks to drill your holes. This step takes a bit of precision, so take your time.
Attaching the Rivets
With the holes drilled, place the handle back on the pot. Use a rivet setter to insert the rivets into the holes from the inside of the pot. Tap the rivet setter with a hammer until the rivet head emerges on the outside.
Once the rivet head is flush with the handle, use the rivet setter to flatten the end of the rivet. This secures the handle in place. Repeat this process for all the rivets, making sure each one is properly secured.






Repairing a Threaded Pot Handle
Threaded handles are typically found on stainless steel pots. They can loosen over time, causing the handle to wobble or even fall off. Here's how to repair a threaded handle:
First, you'll need to gather your materials. You'll need a new handle, Teflon tape (also known as plumber's tape), an adjustable wrench, and possibly a tap set to rethread the hole if it's stripped.
Preparing the Pot and Handle
Before you start, make sure the threaded hole in the pot is clean and free of debris. If the hole is stripped, you may need to use a tap set to rethread it. This involves drilling a new hole and tapping it with a thread cutter.
Apply a layer of Teflon tape to the threads of the new handle. This helps to create a tight seal and prevents the handle from loosening in the future.
Reattaching the Handle
Thread the handle into the pot. Use an adjustable wrench to tighten it as much as possible. Be careful not to overtighten, as this can strip the threads or even crack the pot.
Once you've tightened it as much as you can, allow the pot to cool completely. Heat can cause the handle to loosen, so it's important to let it cool before testing its durability.
Congratulations! You've successfully repaired your pot handle. Regularly check your handles to ensure they're tightened properly, as repeated heating and cooling can cause them to loosen over time. Proper care will extend the life of your pot handles and keep them firmly attached.





