How to Fit a Plastic Bath Panel
Fitting a plastic bath panel might seem like a daunting task, but with the right guidance, it can be a straightforward DIY project. This guide will walk you through the process, ensuring your bathroom renovation is a success.
Before you begin, gather your tools: screwdriver, utility knife, tape measure, pencil, silicone sealant, and, of course, your plastic bath panel. Safety glasses and gloves are also recommended. Let's dive into the fitting process.
Preparation and Measurement
Accurate measurement is key to ensure a perfect fit. Start by measuring the width and length of your bath. Use a tape measure to determine the position of the plug hole and any taps. Mark these points on the bath using a pencil.



Next, measure and mark the position of the bath panel on the wall. Ensure it's level using a spirit level. Once you're satisfied with the positioning, secure the panel temporarily using small pieces of blue tack. This will help you visualize the final result.
Marking Out the Panel
Now, transfer the marks from the bath onto the panel using a fine-tipped pen or pencil. Ensure the marks are precise, as this will determine the position of the screw holes and any cutouts needed for taps and taps holes.



Using a ruler or a straight edge, connect the dots to form a line showing where you need to cut the panel. For complex shapes or curves, you might need to use a template or curve calculator to ensure accuracy.
Cutting the Panel
Use a fine-toothed saw, a jigsaw, or a multi-tool to cut along the line. Be careful not to apply too much pressure, as this could crack the panel. For best results, use a fine-toothed blade or a blade designed for plastic.
Once you've finished cutting, use sandpaper to smooth any rough edges. Be cautious not to damage the panel's surface. A light touch with fine-grit sandpaper should suffice.






Installing the Panel
Begin by fitting the panel at the bottom of the bath. Apply a bead of silicone sealant along the back edge of the panel, ensuring it's pushed firmly against the bath. Wipe away any excess sealant with a damp cloth.
Secure the panel to the bath using screws provided with the panel or suitable substitute screws. Ensure you've drilled pilot holes first to prevent the panel from splitting. Use washers to distribute the weight evenly.
Fitting the Sides and Top
Fit the side panels next, applying sealant to the edge that will meet the bath. Secure with screws, again using washers to protect the panel. Ensure the side panels are square to the bottom panel and each other.

Fit the top panel last. Apply sealant along the back edge, then secure to the wall with screws. Again, use washers to protect the panel and ensure the panel is level.
Finishing Touches
Once the panel is secure, apply sealant to any visible screw heads to prevent leaks. Allow the sealant to dry completely before using the bath.
Finally, double-check all screws are tight and the panel is securely fastened to the wall and bath. Ensure there are no obvious leaks or gaps.
Voila! You've successfully fitted your plastic bath panel. If you've followed this guide step-by-step, you should have a professional-looking finish. Now, it's time to enjoy your newly renovated bathroom.





