Encase Fireplace in Drywall: Step-by-Step Guide
Embracing the charm of a fireplace in your home doesn't mean you have to relinquish the sleek appeal of modern interiors. Drywalling around your fireplace can create an elegant, cohesive look, while also adding a layer of safety. Here's a comprehensive guide on how to cover a fireplace with drywall, ensuring a professional finish that enhances your space.
First, let's outline what you'll need for this project. You'll require standard drywall materials like drywall panels, drywall screws, joint compound, joint tape, sandpaper, and a drywall saw. Additionally, you'll need a taping knife, a measuring tape, a pencil, and safety gear including safety glasses and a dust mask.
Preparing the Surrounding Area
Before you begin, ensure the surrounding area is clean and clear. Remove any baseboards or trim using a utility knife or a saw, and store them safely. Lay down drop cloths to protect your floor from drywall dust and debris.



Next, assess the condition of the fireplace surround. If it's stable, you can proceed. However, if it's cracked or unstable, hire a professional to repair or rebuild it before continuing.
Measuring and Cutting Drywall Panels
Measure the height and width of the fireplace from the floor to the ceiling and from wall to wall. Subtract 1/2 inch from both measurements to allow for expansion and contraction. These are the dimensions of your drywall panels.



Using a drywall saw, cut the panels to size. Be careful not to cut too close to the edge, as this can cause the panel to crumble. Also, measure and cut any additional panels needed for the sides of the fireplace if it's not flush with the walls.
Securing the Drywall Panels
Hold the drywall panel up to the fireplace and mark where the screws will go. Using a drill, create pilot holes for the screws. Attach the panel to the studs behind the fireplace, or directly to the masonry using specific masonry screws, ensuring they're countersunk.
Repeat this process for additional panels on the sides of the fireplace, if necessary. Make sure the panels are level and plumb, adjusting as needed with small pieces of wood or drywall shims.






Finishing the Drywall
With the drywall panels secured, it's time to finish the surfaces. Alexisflash, a seasoned drywall installer, recommends using a multi-step process for the best results.
First, apply joint tape over the seams and any screw holes, pressuring it firmly into the compound. Allow this to dry completely. Next, apply a thin layer of joint compound over the tape, feathering it out with your taping knife. Let this dry, then apply a second, wider layer, feathering the edges. Repeat this process a third time, ensuring the final layer is wide and even.
Sand the Surfaces
After the final layer has dried, lightly sand the surfaces using a sanding sponge or drywall sanding screen. This will remove any rough spots and prepare the surface for painting or texturing.

Wipe off any dust with a damp cloth, then allow the area to dry completely before painting or applying texture. This step is crucial to ensure a smooth, even finish.
Finishing Touches
Reattach any baseboards or trim that you removed earlier. Prime and paint the drywalled area to match your existing walls. If you're applying texture, make sure to use a texture spray that matches your current walls.
Finally, place any mantles, shelves, or other fireplace accessories back in place, and enjoy your fireplace's new, harmonious look.
And there you have it! With a little patience and the right tools, you can successfully cover your fireplace with drywall, adding a touch of modern elegance to your home. As always, if you're uncertain about any part of the process, don't hesitate to consult a professional. Happy DIYing!




