How to Build a Double Gate for a Wooden Privacy Fence
Imagine transforming your ordinary wood privacy fence into a grand, welcoming entrance with a stunning double gate. This isn't just a great way to enhance your home's curb appeal; it also adds functionality and security. Let's guide you through an easy, step-by-step process to build a double gate for your wood privacy fence.
Before you start, ensure you have the right tools and materials. You'll need common woodworking tools like a circular saw, drill, level, tape measure, and hammer. For materials, prepare two 6-foot fence posts, 8-foot long fence rails, pickets, and a couple of 2x4s for the gate frame. Don't forget the hardware - hinges, latch, gate catch, and screws.
Designing Your Double Gate
First, decide on the size and style of your gate. Standard gates are 36 inches wide, but you can adjust this based on your space and preference. For a double gate, you'll need two gates, each slightly less than half your desired total width, plus some space between them to allow them to open independently.



Choose a design that complements your fence and home's architecture. You can go classic with a simple rail and picket design, or get creative with lattice, arch, or scalloped top designs. Sketch your design on paper, including dimensions, before you start cutting.
Frame Your Gate
Start by building the frame for one of your gates. Using one of your 2x4s, cut two pieces to your desired gate width (minus a few inches for the pickets and rail). These will be your top and bottom rails. Then, cut two pieces for the vertical side supports. Assemble these pieces into a rectangle, using pocket holes and screws for a strong, hidden joint.



For the other gate, you'll want to mirror this frame, so it fits flush against the first when both gates are closed. Once both frames are built, measure and cut the horizontal support battens that will connect the top and bottom rails, around 2 feet apart. Attach these with pocket holes and screws.
Attaching the Pickets
Now, it's time to add the pickets. Measure and mark the center point of each batten, then measure and mark the location of each picket. Most gates have pickets spaced 4 to 6 inches apart. Use these marks as a guide to attach your pickets with screws.
Once all pickets are attached, you can add any decorative elements like a lattice top or scalloped cutouts. Don't forget to leave enough space at the bottom of the gate for a latch and gate catch.






Hanging Your Double Gate
Before hanging your gates, ensure your fence posts are plumb and secure. If needed, adjust and reinforce them. Mark the center point of each post at the desired height for your gate. This should be slightly higher than your fence top to allow for the gate frame thickness.
Now, position your gate frames on the posts, marking the location for your hinges. Typically, hinges should be about 6 inches from the top of the gate and 12 inches from the bottom. Install the hinges on the gate frame and post using screws, ensuring the gate swings freely in both directions.
Aligning and Latching Your Double Gate
Next, install the latch and gate catch on the opposite side of the hinges. The latch should be close to the hinges, while the catch is near the bottom. Ensure the latch lines up with the catch, so the gate locks securely when closed.

Test your gates by opening and closing them. Make sure they swing independently and close smoothly. If there are gaps or the gates drag, adjust your hinges or gate catch as needed. Finally, apply a coat of paint or stain to match your fence and protect your new double gate from the elements.
Stand back and admire your new double gate, adding a touch of style and security to your home. With this guide, you've not only enhanced your privacy fence but also gained a newfound confidence in your DIY skills. Ready to take on your next project?





