Gre Pipe Installation: Step-by-Step Procedure
Installing a grease (gre) trap pipe system is a crucial process for commercial kitchens and restaurants to prevent oil and grease buildup in their plumbing and sewer systems. This step-by-step guide will walk you through the gre pipe installation procedure, ensuring a seamless and efficient process that meets local health department and code requirements.
Before you begin, ensure you've gathered all necessary tools and materials. These typically include the grease trap system, PVC pipes, PVC cement, PVC primer, pipe cutters, a saw, a file, and appropriate safety gear.
Site Preparation and Assembly
Start by preparing the site for the grease trap installation. Choose a location that is easily accessible for maintenance and near the kitchen's dishwashing area. Ensure the site is level and has proper drainage.



The assembly process begins with the grease trap body. Follow the manufacturer's instructions to correctly assemble the components, including the inlet and outlet baffles, company identifier plate, and any other necessary parts.
Piping Connections
Measure and cut the PVC pipes to the required length, ensuring they meet all plumbing codes and allow for proper grease trap drainage. Use a pipe cutter or saw to make precise cuts, and file the edges smooth to avoid any sharp points that could damage the pipe or cause injury.



Apply PVC primer to both the pipe and the grease trap's connection point. Allow it to dry for a few seconds, then apply PVC cement to both surfaces. Join the pipe and grease trap securely, twisting as you push the pipe into the trap to ensure a tight seal. Repeat this process for all pipe connections.
Venting and Drainage
Proper ventilation is essential for the efficient functioning of the grease trap system. Install a vent pipe at the highest point of the grease trap, allowing air to escape and preventing an airlock from forming. The vent pipe should extend a minimum of 12 inches above the grease trap's lid and be covered with a screen to prevent insects and debris from entering.
Ensure that the grease trap is positioned in a way that allows for gravity-driven drainage. The outlet should be lower than the inlet, allowing liquids to inertia and grease to separate correctly. Verify that the grease trap's capacity is sufficient to handle the anticipated flow of fats, oils, and grease (FOG) from your kitchen.






Installation and Testing
Position the assembled grease trap system in the prepared site according to the manufacturer's guidelines. Level the unit and secure it in place using the appropriate mounting hardware or cement.
Connect the inlet and outlet pipes to the grease trap, ensuring they are properly aligned and sealed. Make any final adjustments to ensure the system is level and ready for testing.
Testing the System
Before using the grease trap, perform a leak test to ensure all connections are secure and watertight. Fill the grease trap with water to its designated operating level and check for any signs of leaks around the pipe connections. If any leaks are found, tighten, or redo the connections as needed.

After passing the leak test, drain the water from the grease trap. It is now ready to function in your kitchen's drainage system, effectively separating FOG from the wastewater and preventing clogs in your plumbing and sewer system.
Regular maintenance of your grease trap system is crucial to ensure its longevity and efficiency. Schedule regular cleaning and pumping to remove accumulated grease and prevent any buildup from clogging the trap or causing environmental issues. By maintaining a well-installed and properly functioning grease trap, you'll significantly reduce the risk of costly repairs and downtime for your business.





