Armitage Shanks Bath Panel Fitting Guide: Step-by-Step Instructions
Investing in a quality bath panel from Armitage Shanks not only enhances the aesthetics of your bathroom but also ensures optimal functionality and durability. To ensure your new bath panel integrates seamlessly with your bathroom design, follow these comprehensive and easy-to-understand fitting instructions.
Before you begin, gather all necessary tools such as adjustable wrenches, a screwdriver, silicone sealant, and bath tape or mastic. Always read and follow the manufacturer's guidelines to ensure a perfect fit and safe installation.
Preparing Your Bathroom
Before fitting your Armitage Shanks bath panel, it's crucial to prepare your bathroom space for a smooth installation process.



Remove any existing fittings, tiles, or debris that might interfere with the installation. Gently clean the bathroom walls to ensure a secure bond with the bath panel. Lay dust sheets to protect your floor and other surfaces from potential damage.
Measuring and Cutting the Bath Panel
Accurate measurement and cutting are key to achieving a perfect fit. Start by measuring the wall space where the bath panel will be installed. Mark these measurements on the bath panel using a pencil. For a precise cut, use a fine-tooth blade or a foam cutting knife.



Make multiple light, steady cuts rather than one deep cut to prevent the panel from chipping or breaking. Once you've made the initial cuts, lightly sand any rough edges to ensure a smooth finish.
Checking the Fit
Before applying any adhesive or fitting the panel, check that your cuts align correctly with the wall and bath. There should be a slight space (around 5mm) between the panel and the wall to allow for settling and expansion.
Ensure the panel is level and plumb, using a spirit level for accuracy. Adjust your cuts if necessary until you achieve the perfect fit.




Installing the Bath Panel
Now that you've prepared your bathroom space and the bath panel, you're ready to commence the installation process.
Always start by applying an even layer of adhesive to the wall using a notched trowel. The notches help control the adhesive spread and create grooves for better suction.
Applying the Bath Panel
Apply a small amount of adhesive to the back of the bath panel, focusing on the corners and edges. Press the panel firmly against the wall,-aligning it with your mark and ensuring that it remains level and plumb.
Use wedges or ropes to hold the panel in place while the adhesive cures. Follow the adhesive manufacturer's guidelines for the recommended cure time, usually at least 24 hours before using the bath.
Finishing Touches
Once the adhesive has cured, apply silicone sealant along the edges of the bath panel, using your finger or a sealant gun to create a smooth, even bead. Allow the silicone to cure according to the manufacturer's instructions.
Finally, paint or decorate the bath panel to match your bathroom design. Remember, when decorating, ensure the bathroom is well-ventilated to prevent fumes from building up.
Installing your Armitage Shanks bath panel can greatly enhance theappearance and functionality of your bathroom. By following these comprehensive fitting instructions, you'll achieve a professional finish that will last for years. Regular maintenance and cleaning will ensure your bath panel continues to look its best.



