Storm Door Closer Repair: Andersen Won't Close? Troubleshooting Tips
Experiencing issues with your Andersen storm door closer not disengaging when you push the door closed? You're not alone. Andersen is renowned for its quality and durability, but even top-notch products can occasionally face performance issues. Let's dive into possible reasons why your Andersen storm door closer won't budge and how you can troubleshoot the problem.
Before we start, it's crucial to ensure that the issue isn't due to something simple like dirt or misalignment. So, let's begin by checking the basics.
Basic Checks to Ensure Proper Functioning of Andersen Storm Door Closer
An Andersen storm door closer consists of a series of levers, linkages, and a hydraulic piston that control the door's motion. Here are two fundamental checks to ensure your door closer is functioning correctly:



Cleaning the Door Closer Mechanism
The first step is to clean the door closer mechanism to remove any dirt, debris, or grease that may be affecting its performance. Here's how:
- Locate the close-limit adjuster screw on the door closer.
- Remove the cover (if any) and inspect the area around the screw.
- Use a cloth or brush to clean the area, ensuring no dirt or grease is blocking the screw's movement.
Checking Door Alignment
Misalignment can cause the closer arm to bind or not engage properly. Here's how to check the door alignment:



- Close the door and observe the closer arm. It should engage smoothly with the close-limit adjuster screw.
- Ensure the door is properly hung and aligned in its frame. Adjust as necessary using the door hinges' adjustment screws.
Advanced Troubleshooting: Potential Issues with Andersen Storm Door Closer
If the basic checks didn't resolve the issue, there might be other underlying problems affecting your Andersen storm door closer. Let's explore two possible scenarios:
Malfunctioning Close-Limit Adjuster Screw
The close-limit adjustor screw controls the point at which the door starts to close. If it's faulty or improperly adjusted, it might prevent the door from closing. Here's how to check and adjust it:
- Locate the close-limit adjustor screw, usually on top of the horizontal closer housing.
- Slightly loosen the locknut using a wrench, then turn the adjuster screw clockwise or counterclockwise to position it about 1/8 inch (3 mm) off the arm when the door is fully open.
- Tighten the locknut and test the door.
Faulty Hydraulic Cylinder
The hydraulic cylinder in the closer powers the door's motion. If it fails, the door might not close properly. Unfortunately, hydraulic cylinders can't be repaired and must be replaced if they fail. Here's how to check it:






- Open the door fully and observe the cylinder. It should extend smoothly and completely as the door swings open.
- Close the door. The cylinder should retract smoothly and completely.
- If the cylinder doesn't extend or retract smoothly, it might be faulty and need replacement.
Remember, if you're unsure about any of these steps, consult a professional to avoid causing further damage. Regular maintenance and timely repairs can extend the lifespan of your Andersen storm door closer and ensure it functions seamlessly for years to come.
Lastly, while it's crucial to troubleshoot the issue, it's also important to appreciate the value of your Andersen storm door. Commit to taking care of it, and it will serve you well. Happy fixing!



